There are a number of reasons why you might have to reset your smart code door lock. These include changing the settings on the lock, adding new user codes or deleting user codes. The following steps can help you to accomplish this task.
Contents
Remove the interior cover window
There are many things to choose from when it comes to smart home security. In particular, a keypad-controlled door lock can be finicky. Fortunately, there are many simple tricks of the trade you can employ to get your door locks to work like the proverbial well behaved cat. If your Kwikset isn’t performing up to par, it’s time to roll up your sleeves and get to the business of protecting your prized possessions.
One such trick is to remove the interior cover of the lock. The cover can be unscrewed from its underlying panel by means of two screws. Once the cover is freed of its mate, you’re ready to go. You may have to unhook the aforementioned security screw first. It’s best to do so before removing the battery pack.
Once you’ve got the cover off, the battery pack isn’t far behind. If you’re going to be replacing the batteries anyway, it makes sense to take the time to do it the right way.
Disconnect the battery pack
In order to reset a Schlage smart code door lock, you must first disconnect the battery pack. Once the lock is reset, you’ll need to add new user codes. This process can be done by either pressing the Program button or the A button for a few seconds.
If you don’t have an original lock manual, you can find the factory preset codes in your Installation and Programming Guide. The button locations are also listed in these guides.
When you are resetting a Schlage lock, you will hear several beeps. It should stop beeping after a few minutes. You will also see the lock status LED flash green. After a few hours, the low battery indicator will be gone.
In addition to replacing the battery pack, you may need to remove the battery cover from the inside of the lock. Make sure to replace the battery cover with new screws.
You should also take care to ensure that the power cable is free of damage. A damaged power cable will prevent the lock from working properly.
Add or delete user codes
If you have a Kwikset SmartCode Door Lock, you may need to reset it for safety or convenience reasons. Luckily, it is easy to do. Whether you need to remove or add a user code, this article will guide you through the process.
Before you begin, be sure to remove any other access codes that are connected to your smart lock. To do this, hold the program button down for at least 30 seconds.
You will see a flashing green light indicating that the lock has been successfully reset. It’s a good idea to check the lock’s status LED while you’re at it.
Now, you can enter a new user code. Enter a 4-digit or 8-digit number. Make sure the first four digits are unique. After you’ve done that, you should get a buzzer to confirm the new user code.
Adding a code to your Kwikset SmartCode lock is a good way to give guests and visitors a secure entry. Deleting old user codes frees up space for new ones.
Confirm that the lock has been successfully reset
If your smart code door lock is not working as it should, you may have to reset it. In order to reset it, you will need to follow the steps below.
First, you will need to open the lock and remove the batteries. Then, you will need to press and hold the A or Program button for thirty seconds. This will remove all of the codes that were previously set on the lock.
You will also need to follow the instructions in your installation and programming guide. These guides will specify the location of the buttons that you will need to push.
Next, you will need to connect the lock to your smart home system. It is important to make sure you have a Wi-Fi network in your home, as the smart lock will require it to function.
To confirm that the smart code door lock has been reset, you will need to open the door. When the lock is locked, you will see a grey circle on the screen. Once the circle turns green, you will know the smart lock has been reset.
